Purchase SignTools 4 together with CorelDRAW X8
starting at
only
$419 AUD
This is the most powerful vinyl cutting and sign making
package combination available, at a fraction of the cost of high end sign
programs.
For more information click here.
SignTools Settings
After installing CorelDRAW the next step is to install SignTools. Follow the instructions on page 4 and 5 of the SignTools 4 User Guide.
Once you have installed SignTools, open Corel Draw and click on the Application Launcher (see picture below) and choose SignTools 4.
Next click on the "Cut"
button and then the "Cut Settings" Button. Select the Infiniti
FY 1350 from the "Cutter" drop down box
and select your port.
If you are using a Serial (Com) port click on the Properties
button and set the following settings:-
Bits per second : 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow Control: Hardware
USB
Connection Setup
If you are using a USB connection you may have to install the Windows driver that comes with the plotter, so that the USB port can be selected in SignTools.
Plotter Cable
Please ensure that your Serial (Com) cable is a RS 232-C cable. SignTools will not communicate with your Gerber plotter with a different cable. If you are unsure if your cable is a RS 232-C cable, contact your plotter distributor.
CorelDraw Settings
In CorelDraw's Layout menu select Page Setup. A dialog box
will appear. Set Width to 3200mm (123 inches) and Height to 1350mm (53.1 inches).
Ensure that you are using a Landscape page.
To set this as a default page in CorelDRAW click on the Tools menu and choose Options. Click on the word Document on the left hand side and ensure all of the options are ticked and click on the OK button.
To cut any object in CorelDraw, simply place on the page in the bottom left corner. If you wish to cut in a portrait fashion simply rotate your graphics.
Additional note
SignTools 4 cuts from the bottom left of the page either manually place object(s) in the bottom left of the CorelDRAW page or use the "Vinyl Saver" tool with the sliding bar all the way to the left.