signtools4.com

Buy CorelDRAW & Get SignTools 4 FREE



 $799 AUD
  including International Shipping

For more information click here.

 

 SignTools 4 For CorelDRAW



Roland STX-7 Vinyl Cutter Setup instructions

 

SignTools Settings
 

After installing CorelDRAW the next step is to install SignTools. Follow the instructions on page 4 and 5 of the SignTools 4 User Guide.

 

Once you have installed SignTools, open Corel Draw and click on the Application Launcher (see picture below) and choose SignTools 4.

 

CorelDraw Application Launcher

 

 

Next click on the "Cut" button and then the "Setup" button. Select the Roland Stika STX-7 from the "Device" drop down box and select your port.


CorelDraw Settings

In CorelDraw's Layout menu select Page Setup. A dialog box will appear. Set Width to 1000mm (39.4 inches) and Height to 160mm (6.3 inches).

Ensure that you are using a Landscape page.

CorelDraw Landscape Page
 

To set this as a default page in CorelDRAW click on the Tools menu and choose Options. Click on the word Document on the left hand side and ensure all of the options are ticked and click on the OK button.

To cut any object in CorelDraw, simply place on the page in the bottom left corner. If you wish to cut in a portrait fashion simply rotate your graphics.


Additional note

SignTools 4 cuts from the bottom left of the page either manually place object(s) in the bottom left of the CorelDRAW page or use the "Vinyl Saver" tool with the sliding bar all the way to the left.

 

Further support

If you have followed these instructions and are still having problems setting up your vinyl cutter go to our support page and fill in the Support Enquiry Form.